MIB database management (backup and
restore)
202
WebEML User Manual
See the 9500 MPR Product Information Manual for information about the parameters
that are stored and excluded from the backup file.
It is recommended that excluded parameters be saved by running an NE Inventory
report, so these parameters may be reprovisioned in the event that the system needs
to be restored from scratch.
After completing the restore operation, the restored database must be activated to
apply the downloaded parameters to the NE. Upon activation of the restored
database, the NE will automatically restart.
Database backup should be performed with no forced protection switches active. A
system restored with a backup database that was saved while forced protection
switches are active, may result in the system being restored to an unknown state. If
this occurs, communications with the system may be difficult to reestablish and may
result in the loss of traffic.
25.3 Procedure
This section provides the following procedures:
• To backup the MIB management database
• To restore the MIB management database
• To activate the MIB management database
To backup the MIB management database
1. Select Protection Schemes tab.
2. Verify that no forced protection switches are active.
3. Are forced protection switches active?
a. If yes, go to step 4.
b. If no, go to step 5.
4. Determine if the active forced protection switches can be released. Release all
forced protection switches prior to proceeding with this procedure.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...