Log in to and out of system
96
WebEML User Manual
To log in using JUSM
1. Is NEtO currently running?
a. If no, go to step 5.
b. If yes, go to step 6.
2. Double-click on the WebEML icon on the desktop to launch NEtO. See
Figure 15.
Figure 15 WebEML icon
The NEtO Servers Manager window opens. See Figure 16.
Figure 16 NEtO Servers Manager window
Then the NEtO window opens. See Figure 17.
Note: If the software version of the 9500 MPR NE does not match one of the installed
software versions of the NEtO/JUSM/CT, the login may fail. This login failure manifests in
the following three failure modes:
•After clicking OK on the NEtO NE info area, a warning message displays, ‘Start supervision
failed. NE’s type or release is not supported.’
•After entering the username and password, an error message displays, ‘SW license not
supported: JUSM will be closed.’
•After entering the username and password, the login progress window hangs up at
approximately 40% completed.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...