WebEML User Manual Administer L1/L2 radio and L2 Ethernet LAG
ports
307
41.3 Procedures
This section provides the following procedures:
• To launch the LAG Configuration tool
• To provision an L1 Radio LAG port
• To provision an L2 radio LAG port (not available with a CorEvo card)
• To create an L1/L2 Radio or L2 Ethernet LAG port
• To add Ethernet or radio ports to LAG port
• To remove Ethernet or radio ports from a LAG port
• To enable a LAG port
• To destroy an L2 Ethernet or L1/L2 Radio LAG port
• To administer PPP RF configuration
• To provision hashing level for L2 Ethernet/radio LAG port
• To enable SSM support for L1 radio LAG port
• To enable PTB for L1 radio LAG port
• To provision Wait-To-Restore (WTR) value
To launch the LAG Configuration tool
1. Launch Link Aggregation L1/L2 Configuration (LAG Configuration) tool from the
craft terminal. Click the LAG Configuration Icon, see Figure 166, or from the
main menu bar, select Configuration > LAG Configuration.
Figure 166 LAG Configuration icon
LAG Configuration tool opens. See Figure 167.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...