Nokia 9500 MPR - Page 318

Administer L1/L2 radio and L2 Ethernet LAG
ports
318
WebEML User Manual
Figure 172 Add Ethernet ports to Ethernet LAG
i. From the Configured LAGs pane, select LAG to add port.
ii. If LAG Type is provisioned L2 Radio, then from the Available Ports pane,
select Radio port type (MPT).
iii. From Available Ports pane, select port to add to LAG.
iv. Click >.
v. If Type is provisioned L2 Ethernet, then from the Added Ports pane, select
priority (0 or 65535).
Note: default priority value is 128.
vi. Repeat steps i through v to add additional ports to the LAG.
vii. Click Apply.
To remove Ethernet or radio ports from a LAG port
1. Using the LAG Configuration Tool Settings tab, remove Ethernet/Radio ports
from LAG port using the following procedure:
To remove L1 Radio port from LAG port, see Figure 173.
To remove L2 Radio port from LAG port, see Figure 174.
22901
vvii
i
iii
iv
Release 7.0.0 3DB 19286 ACAA Issue 01