WebEML User Manual Administer system settings
173
22 Administer system settings
22.1 Purpose
This chapter provides procedures to administer system settings.
22.2 General
The Systems Settings/NE Configuration screen is used to configure the DHCP
Server support, Ethernet LOS Criteria, Static Lag Criteria, System Priority
Parameter, event and alarm logging, SNMP mode, and retrieve the NE MAC
Address/Bridge Address.
22.2.1 Tributary Port Configuration (ETSI market only)
This field allows to set the suitable impedance of the E1 stream.
22.2.2 DHCP server support
The default setting for DHCP server support is enabled. In most configurations this
is the recommended provisioning value.
The DHCP should be disabled when using the local TMN port for a network
connection. This enables the alarm reporting on the port.
The DHCP should be enabled when using the local TMN port for a temporary CT port
that will be left disconnected during normal operation. This disables the alarm
reporting on the port.
DHCP provisioning is supported from both the craft terminal and the Web Server.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...