Enable equipment
486
WebEML User Manual
Figure 302 EASv2 enabled
5. Verify port segregation provisioning. Port segregation should be provisioned
between the EASv2 Ethernet ports and other Ethernet and/or radio ports where
connectivity is not desirable. See Provision port segregation/connectivity for
detailed steps to view/provision port segregation.
To enable an MPT-HL or MPT-HLC transceiver card on P8ETH or EASv2 card
1. Select the slot where the card is equipped to support MPT-HL/MPT-HLC
Transceiver in the resource tree area. The selected name will highlight in blue.
This selection also highlights the card in blue on the graphical representation of
the MSS shelf in the resource list area.
2. Click the Settings Tab in the resource detail area. See Figure 303.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...