WebEML User Manual Configure AUX cross connections (ETSI market
only)
403
46 Configure AUX cross connections (ETSI
market only)
46.1 Purpose
This chapter provides instructions and sequence for configuring AUX cross
connections.
46.2 General
Two types of AUX Cross-Connections can be implemented:
• Local User Service Channel Cross-Connection
• Service Channels Cross-connection in pass-through
46.2.1 Service Channels Cross-connection in pass-
through
Independently of the presence of the Auxiliary peripheral unit, it is always possible to
cross-connect each individual radio Service Channel with a radio Service Channel of
another radio direction, without any local termination.
46.3 Procedures
This section provides the following procedures:
Note: Cross-Connection towards MPT
In this release cross-connection of Service Channels towards a radio direction with MPT is
not supported.
The operator therefore will not have the possibility to select a radio direction with MPT for
such cross-connection.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...