WebEML User Manual Perform debug functions using the Web Server
285
38 Perform debug functions using the Web
Server
38.1 Purpose
This chapter provides procedures for performing debug functions using the Web
Server interface.
38.2 General
The Debug Info menu allows the operator to analyze Ethernet traffic using a web
browser.
The following commands are available:
• ping: tries to establish a connection to an IPv4 address. When this command is
selected, a window opens: enter the IP address to ping.
• ping6: tries to establish a connection to an IPv6 address. When this command
is selected, a window opens: enter the IP address to ping.
• Database scratch web page: provides information on scratching the NE
database. This command is available with MSS-1 only.
• General Debug: creates a set of trace logs for the system and displays the
location of the log files.
• General Debug -r: removes the saved log files from the last General Debug.
• Networking Debug: lists the configured links with IP address and Tx and Rx log
information.
• ConfigFile List: shows the file names of the configuration files that were used to
configure the NE.
• Ring Debug: shows interoperability information, alarm status and BCM STG
information for each Ring configured
• Switch Buffers debug: shows the buffer configuration and utilization per chip, per
port and per QoS queue.
• Bridge debug: provides configuration information for Provider Bridge ports.
• Vlan Show: lists the configured VLANs inside the NE with the ports member of
VLAN (VLAN member set) and ports where VLAN Tag is removed in egress
(VLAN untagged set).
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...