Nokia 9500 MPR - Figure 248 Provision Per-VLAN Per-Cos Rate Limiting

WebEML User Manual Provision Ethernet ports
423
c. Provision VLAN Rate Limiter - Ingress mode?
a. To enable, select VLAN Enabled (checked), then go to step d.
b. To disable, select VLAN Enabled (unchecked), then go to step f.
d. VLAN Select the Ingress CIR value (Kbit/s).
e. Select the Ingress Max Burst size (Kbit/s).
f. Click on the Apply button.
To provision Per-VLAN Per-CoS (Class of Service) rate limiting
1. Provision Per-VLAN Per-CoS Rate Limiter parameters using the following
procedure. See Figure 248.
Figure 248 Provision Per-VLAN Per-CoS rate limiting
Caution: When a Per-VLAN Per-CoS Rate Limiter is activated in conjunction with a Port
Rate Limiter, the Per-VLAN Per-CoS Rate Limiter must apply to Ethernet frames that meet
the Port Rate Limiter parameters.
e
a
b
d
g
f
23045
c h
Release 7.0.0 3DB 19286 ACAA Issue 01