Nokia 9500 MPR - Figure 208 PDH to RING Cross Connection

Provision cross connections
376
WebEML User Manual
Figure 208 PDH to RING Cross Connection
3. On the PDH-RING pop-up, select the ERP Instance to be cross connected.
4. On the PDH-RING pop-up, select the check boxes for all Flow ID numbers to be
cross-connected.
5. On the PDH-RING pop-up, click OK.
6. On the Cross Connection screen, click Apply.
7. From the Connections tab, verify the PDH-RING cross-connection was entered
correctly.
To provision a Radio to Ring Cross Connection
Caution: When parallel radio paths exist between two MSS shelves, port
segregation should be provisioned between the parallel radio paths at both ends
to prevent a loss of traffic.
Release 7.0.0 3DB 19286 ACAA Issue 01