Nokia 9500 MPR - Figure 528 NE F to Node C (Protected): Pass-Through Cross-Connection on Node D

WebEML User Manual Provision cross connections in a mixed fiber/
microwave Ring
713
Figure 528 NE F to Node C (protected): pass-through cross-connection on Node D
a. Choose the flow IDs to cross-connect from the Available VLANs list
b. Choose the Service profile: TDM2TDM or TDM2ETH
c. Choose the Clock Source, if the Service profile is TDM2ETH
d. Enter the Ring Destination MAC address: Node C Multicast MAC address
e. Enter the Ring Source MAC address: NE F Unicast MAC address
To provision a cross-connection between NE F (protected) and Node C (protected)
1. One traffic end point is connected using Ethernet to the fiber chain. Both end
points are protected, see Figure 529.
Release 7.0.0 3DB 19286 ACAA Issue 01