WebEML User Manual Configure radio parameters
785
59 Configure radio parameters
59.1 Purpose
This chapter describes the radio parameters and provides procedures to configure
radio parameters.
59.2 General
To aid in correct provisioning of the radio parameters, establish communication with
the radio (MPT-HC, MPT-HC-HQAM, MPT-XP, MPT-XP-HQAM, 9558HC, MPT-HL,
MPT-HLC, or MPT-HLS).
To provision an MPT ODU radio port, one of the following must be provisioned for
each MPT ODU:
• Ethernet port on an enabled Core card
• Radio ports on an enabled MPTACC (MPT Access) card
• SFP ports on an enabled P8ETH card
• SFP ports on an enabled EASv2 card
• Ethernet ports on an MSS-1 unit: communication with the MSS-1 unit must be
established.
• Ethernet ports on an MSS-O unit: communication with the MSS-O must be
established.
To provision the MPT-HL/HLC/HLS radio parameters, one of the following must be
provisioned for the MPT-HLx:
• SFP port on an enabled Core card
• SFP ports on an enabled P8ETH card
• SFP ports on an enabled EASv2 card
• SFP ports on an MSS-1 unit: communication with the MSS-1 unit must be
established
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...