Nokia 9500 MPR - Figure 308 Enabled MPT-HL;MPT-HLC on Core-E

Enable equipment
492
WebEML User Manual
Figure 308 Enabled MPT-HL/MPT-HLC on Core-E
5.
Verify port segregation provisioning. Port segregation should be provisioned
between parallel MPT-HL/MPT-HLC radio paths at both ends when they exist on
the NE. Port segregation should be provisioned between the Core MPT-HL/
MPT-HLC port and other Ethernet and/or radio ports where connectivity is not
desirable. See Provision port segregation/connectivity for detailed steps to view/
provision port segregation.
To enable an E1/DS1 P32E1DS1 card
1. To enable an E1/DS1 P32E1DS1 card
Select MSS-n/Slot# (slot 3 through 8) in the resource tree area where the
P32E1DS1 card will be enabled. The selected slot will highlight in blue. This
selection also highlights the selected slot in blue on the graphical representation
of the MSS shelf in the resource list area. See Figure 309.
Caution: When parallel radio paths exist between two MSS shelves, port
segregation should be provisioned between the parallel radio paths at both ends
to prevent a loss of traffic.
Release 7.0.0 3DB 19286 ACAA Issue 01