Nokia 9500 MPR - Figure 203 SDH to LAG Configuration Dialog

WebEML User Manual Provision cross connections
369
7. From the Connections tab, verify the SDH_RING cross-connection was entered
correctly.
To provision an SDH to LAG Cross connection
1. Verify port segregation provisioning. Port segregation should be provisioned
between parallel radio paths at both ends when they exist on the NE. Also port
segregation should be provisioned between the radio port and other Ethernet
and/or radio ports where connectivity is not desirable. See Provision port
segregation/connectivity for detailed steps to view/provision port segregation.
Select SDH port and drag to draw line to an L1 LAG on an EASv2 card.
SDH-RADIO LAG pop-up displays. See Figure 203.
Figure 203 SDH to LAG configuration dialog
2. On the STM-1_RADIO LAG pop-up, verify the Flow Id to be cross connected.
Release 7.0.0 3DB 19286 ACAA Issue 01