Use the Provisioning Tool
940
WebEML User Manual
Figure 708 Network Configuration screen
Configure the following IP addresses:
− Local IP Address: it is the Controller IP address (default IP address =
10.0.1.2 with fixed mask 255.255.255.255)
The NE Local IP Address can be reused on one of the other TMN interfaces.
These interfaces must have different IP subnets.
− NMS Ethernet Port IP address: it is the IP address relevant to the Ethernet
TMN port (default IP address = 10.0.1.2 with mask 255.255.255.0)
The NMS Eth port cannot be disabled.
− NMS Ethernet Port 4 IP address: the Ethernet Port 4 can be used for traffic
or TMN depending on the configuration on the Core Configuration screen.
Port 4 area is configurable if ETH4 area in Core configuration screen is set
in “TMN” Working Mode. If the area is enabled, it behaves the same as for
Ethernet Configuration.
− TMN In-Band interface #1, IP/subnet;TMN In-Band interface #2, IP/subnet
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...