Administer In-Band TMN VLAN port
122
WebEML User Manual
• PCP value between 0 and 7. Default is 7.
• IP Routing Protocol: Static/OSPF
− When OSPF routing protocol is selected: OSPF Area Number must be
provisioned.
− OSPF Area must be provisioned prior to provisioning the In-band TMN
Ethernet interface
In-band TMN Ethernet interface IP address must satisfy the following rules:
• IP address can be equal to the local IP address, but must be different from
Port#4 TMN interface port IP address
• IP address 0.0.0.0 is not supported
• IP addresses 127.0.0.0 to 127.255.255.255 are not supported
In-band TMN Ethernet interface sub-network mask must satisfy the following rules:
• Sub-network Mask 0.0.0.0 is not supported
• Sub-network Mask 255.255.255.255 is not supported
• Sub-network Mask assigned to the In-band TMN Ethernet interface must be
different than the Port#4 TMN Ethernet interface
Each IPv6 In-band TMN Ethernet interface requires the following:
• Unique IP address with FE80::/64 as high-order bits
− TMN In-Band #1 default IP address: FEC0:0:0:3::1/64.
− TMN In-Band #2 default IP address: FEC0:0:0:4::1/64.
• Uses the same MAC address as Port#4 TMN Ethernet interface
• Unique VLAN ID (2-4080).
• IP Routing Protocol: Static/OSPFv3
− When OSPFv3 routing protocol is selected: OSPFv3 Area Number must be
provisioned.
− OSPFv3 Area must be provisioned prior to provisioning the In-band TMN
Ethernet interface
In-band TMN Ethernet interface IP address must satisfy the following rules:
• IPv6 addresses having the Interface ID portion equal to all 0 are not allowed
• IPv6 address::/128 (Unspecified address) is not allowed
• IPv6 address::1/128 (Loopback Address) is not allowed
• IPv6 addresses having FF00::/8 as high-order bits (Multicast addresses) are not
allowed
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...