Provision Ethernet ports
410
WebEML User Manual
• To enable an Ethernet port
• To disable an Ethernet port
• To provision Ethernet port capabilities parameters
• To provision Ethernet port VLAN configuration parameters
• To provision synchronous Ethernet operation mode parameters
• To provision Hold off timer for Core Ethernet ports in a Ring
• To provision provider bridge parameters
• To provision rate limiting by port
• To provision Ethernet port storm control
• To provision rate limiting by VLAN
• To provision Per-VLAN Per-CoS (Class of Service) rate limiting
• To delete Per-VLAN Per-CoS rate limiting
To select the card to provision Ethernet port
1. Select MSS/Core-Main slot #1, MSS/P8ETH slot #n, MSS/EASv2 slot #n or
MSS/CORE slot #1 in the resource tree area. The selected name will highlight
in blue. This selection also highlights the card in blue on the graphical
representation of the shelf in the resource list area. The radios connected to the
card are displayed in the resource list area.
For an example of the Core-E card, see Figure 236.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...