Configure radio parameters
800
WebEML User Manual
26. Select Equipment Protection in the resource tree area.
27. From the Restoration Criteria panel, verify the Restoration Criteria selection and
provision if required:
i. Select the Not Revertive or Revertive radio button.
ii. Click Apply.
28. Select HSB Protection in the resource tree area.
29. From the Restoration Criteria panel, verify the Restoration Criteria selection and
provision if required:
i. Select the Not Revertive or Revertive radio button.
ii. Click Apply.
30. Select Rx Radio Protection in the resource tree area.
31. From the Restoration Criteria panel, verify the Restoration Criteria selection and
provision if required:
i. Select the Not Revertive or Revertive radio button.
ii. Click Apply.
32. Provision the MPT-HL link identifier
Open the appropriate radio main view depending on your radio configuration
and select the Additional Settings tab; see Figure 603.
Note: For 1+1 FD protection type, HSB Protection is not available.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...