WebEML User Manual Configure radio parameters
821
49. Select Equipment Protection in the resource tree area.
i. From the Restoration Criteria panel, verify the Restoration Criteria selection
and provision if required:
ii. Select the Not Revertive or Revertive radio button.
iii. Click Apply.
50. Select HSB Protection in the resource tree area.
51. From the Restoration Criteria panel, verify the Restoration Criteria selection and
provision if required:
i. Select the Not Revertive or Revertive radio button.
ii. Click Apply.
52. Select Rx Radio Protection in the resource tree area.
53. From the Restoration Criteria panel, verify the Restoration Criteria selection and
provision if required:
i. Select the Not Revertive or Revertive radio button.
ii. Click Apply.
54. Provision the MPT-HLC link identifier
Open the appropriate radio main view depending on your radio configuration
and select the Additional Settings tab; see Figure 619.
Danger: For 1+1 FD protection type, HSB Protection is not available.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...