WebEML User Manual Configure radio parameters
845
ii. Enter the Expected Identifier value (0 to 255).
iii. Enter the Sent Identifier value (0 to 255).
iv. Click Apply.
56. Provision the MPT-HLS Synchronization Status Messaging
Open the appropriate radio main view depending on your radio configuration
and select the Additional Settings tab; see Figure 633.
57. Provision MPT-HLS radio channel Synchronization SSM:
i. Select the Synchronization SSM Enabled check box.
ii. Click Apply.
58. Provision the MPT-HLS Point to Point Protocol settings
Open the appropriate radio main view depending on your radio configuration
and select the Additional Settings tab; see Figure 633.
Provision MPT-HLS radio channel PPP:
i. From the PPP RF panel, select the Enabled check box.
ii. Select the Routing IP Protocol: (OSPF or None).
iii. If OSPF is selected, then select OSPF Area: (0 to 4).
iv. Click Apply.
59. Provision the PKT throughput booster setting
Note: If the MPT-HLS is part of a LAG, you cannot change the SSM or PPP settings on an
individual radio. Go to Administer L1/L2 radio and L2 Ethernet LAG ports to administer LAG
ports.
Note: If the MPT-HLS is part of a LAG, you cannot change the SSM or PPP settings on an
individual radio. Go to Administer L1/L2 radio and L2 Ethernet LAG ports to administer LAG
ports.
Note: OSPF Area must be provisioned prior to provisioning the PPP RF channel.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...