WebEML User Manual Configure radio parameters
875
69. Provision the MPT ODU Point to Point Protocol settings
i. From the PPP RF panel, select the Enabled check box; see Figure 656.
ii. Select Routing IP Protocol: (OSPF or None).
iii. If OSPF is selected, then select OSPF Area: (0 to 4).
NOTE: OSPF Area must be provisioned prior to provisioning PPP RF
channel.
iv. Click Apply.
70. Provision the PKT throughput booster setting
i. From the Pkt Throughput Booster panel, select the Enabled check box; see
Figure 656.
ii. Click Apply.
71. Administer the MPT ODU Alarm Profile settings
i. In the Alarm Profile panel, click on the icon; see Figure 656. The Alarm
Severity Profile window opens.
ii. Choose an alarm severity profile. Select the Show details button for more
information if needed.
iii. Click Apply.
72. Provision the MPT ODU radio channel encryption
If the radio is remotely managed, the encryption should be configured on the
remote radio before the local one. The configuration change will cause the
remote radio to become temporarily unreachable until the local radio is also
configured.
Encryption mismatch is not part of the switching criteria for L1 LAG or ERPS. To
avoid traffic interruption if the radio is part of an L1 LAG or ERPS topology, mute
the transmitter before configuring encryption.
Open the appropriate radio main view depending on your radio configuration
and select the Additional Settings tab; see Figure 656.
If the radio is part of an L1 LAG or ERPS topology, mute the transmitter; see To
administer the Tx Mute settings.
i. Click on the Edit passphrase button.The Edit passphrase window opens.
Note: Before provisioning radio channel encryption, verify the radio channel is running error
free and operating correctly.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...