WebEML User Manual Upgrade MPT ODU to MPT ODU L1 LAG port
1069
3. Install optical Ethernet fiber from MSS-4/8 shelf to MPT ODU as required per
site documentation.
4. Verify that the MPT ODU radio interface is not associated with the following:
a. Cross-Connection
b. VLAN
c. Port Segregation
d. PPP RF enabled
e. Synchronization reference
f. SSM
5. Perform a database backup. See MIB database management (backup and
restore) for a detailed procedure to perform a database backup.
6. If MPT ODU radio interface is configured for 1+1 HSB/FD/SD, downgrade radio
protection to 1+0. See Upgrade and downgrade protection for a detailed
procedure.
7. Disable MPT ODU radio port from MPTACC card. See Disable equipment for a
detailed procedure.
8. If MPTACC PFoE is the power source for the MPT ODU, verify the power source
is still configured for PFoE.
9. If MPTACC card is to be replaced with P8ETH card to support L1 LAG port.
Perform the following actions:
a. Verify no radio interfaces are supported on the remaining MPTACC radio
interface. If there is a radio interface connected to the remaining MPTACC
radio port, STOP this procedure immediately and contact the next level of
support!
b. Disable MPTACC card. See Disable equipment for a detailed procedure.
c. Remove the MPTACC card from the MSS-4/8 shelf.
d. Install the P8ETH card into the MSS-4/8 shelf.
10. Verify/enable P8ETH card to support L1 LAG port.
11. Install SFP into the P8ETH radio port and connect fiber cable to SFP. L1 LAG
Master port must reside in P8ETH Ethernet port 5 or 7.
12. Install SFP into the MPT ODU data port and connect the fiber cable to the SFP
per site documentation.
13. Provision MPT ODU radio interface.
Note: Electrical SFPs are not supported for interconnection between P8ETH SFP port and
MPT ODU.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...