WebEML User Manual Provision protection scheme parameters
763
57 Provision protection scheme parameters
57.1 Purpose
This chapter provides procedures to provision Protection Schemes for the 9500
MPR.
57.2 Procedures
This section provides the following procedures:
• To view protection schemes
• To provision the Equipment Protection Schemes parameter
• To provision the Hot StandBy Protection Schemes parameter
• To provision Rx Radio Protection Schemes parameters
To view protection schemes
1. Select Protection Schemes Tab.
The Protection Schemes tab opens. See Figure 576.
All the protection schemes provisioned for the 9500 MPR radio are displayed in
the main window pane.
2. Expand Protection Schemes in the resource tree area.
Note: If an RF loopback is in place with MPT-HLC, you need to remove it before configuring
protection.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...