Provision Protection Type
772
WebEML User Manual
58.4 Procedure
This section provides the following procedures:
• To provision MPT-HL or MPT-HLC Transceiver Protection Type
• To provision E1/DS1 Protection Type
• To provision DS3 Protection Type
• To provision SDH Protection Type
• To provision MPT ODU Protection Type
To provision MPT-HL or MPT-HLC Transceiver Protection Type
1. Select MPT-HL Dir#-Ch# or MPT-HLC Dir#-Ch# in the resource tree area. The
selected name will highlight in blue. This selection also highlights the MPT-HL/
HLC Transceiver icon in blue in the resource list area.
2. Select Settings tab. See Figure 584.
Note: Spare MPT-HL/HLC Transceiver must be enabled prior to provisioning MPT-HL/HLC
Transceiver protection type.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...
