Configure radio parameters
824
WebEML User Manual
62. In the Alarm Profile panel, click on the icon. The Alarm Severity Profile window
opens.
63. Choose an alarm severity profile. Select the Show details button for more
information if needed.
64. Click Apply.
65. Provision the MPT-HLC radio channel encryption
If the radio is remotely managed, the encryption should be configured on the
remote radio before the local one. The configuration change will cause the
remote radio to become temporarily unreachable until the local radio is also
configured.
Encryption mismatch is not part of the switching criteria for L1 LAG or ERPS. To
avoid traffic or supervision interruption if the radio is part of an L1 LAG or ERPS
topology, execute a mute procedure of the radio link before configuring
encryption. Proceed radio link by radio link.
Open the appropriate radio main view depending on your radio configuration
and select the Additional Settings tab; see Figure 619.
66. If the radio is part of an L1 LAG or ERPS topology, mute the transmitter; see To
administer the Tx Mute settings.
67. Provision the radio channel Encryption:
i. Click on the Edit passphrase button.The Edit passphrase window opens.
ii. Enter and confirm the new passphrase.
iii. Click Apply in the Edit passphrase window.
68. Administer the RX squelch settings
Open the appropriate radio main view depending on your configuration and
select the Maintenance tab.See Figure 620.
Note: Before provisioning radio channel encryption, verify the radio channel is running error
free and operating correctly.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...