WebEML User Manual OAM Remote Loopback
975
66 OAM Remote Loopback
66.1 Purpose
The procedures in this chapter are used to perform an EFM OAM remote loopback.
66.2 General
A loopback can be performed on an operational EFM OAM link.
The following conditions must be satisfied in order to activate remote loopback:
• Local DTE in Active mode
• Operational Status value is Operational
• Remote DTE supports Remote Loopback function
• Local DTE not in loopback mode
66.3 Procedure
This section provides the following procedures:
• To activate OAM Remote Loopback
• To activate OAM Remote Loopback
To activate OAM Remote Loopback
1. From the Main Menu Bar, select Configuration >ETH OAM Configuration.
The ETH OAM Configuration window opens. See Figure 733.
Note: OAM Remote loopbacks do not generate an Abnormal Condition.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...