WebEML User Manual Administer synchronization
337
2. Select Synchronization Source in the resource tree area.
3. Select the Settings tab in the resource detail area.
Synchronization Settings tab displays. See Figure 182.
4. Select the Master radio button in the Role partition.
5. Select a Restoration mode radio button: Revertive or Not Revertive.
6. Select a Primary Source radio button: Free Run Local Oscillator, E1/DS1 Port,
Sync-In Port, Eth Port, or STM-1/OC-3 Port.
7. Which primary source was selected?
a. If Sync-In Port, go to step 8.
b. If E1/DS1 Port, go to step 11.
c. If Eth Port, go to step 14.
d. If STM-1/OC3 Port, go to step 17.
e. If Free Run Local Oscillator, go to step 29.
8. In the Sync Ports partition, from the Sync In Port drop-down menu, select Sync
In Port frequency: 1.024 MHz, 2.048 MHz, 5 MHz, or 10 MHz.
9. Select Secondary Source radio button: Free Run Local Oscillator, E1/DS1
Port, Eth Port, STM-1/OC-3 port, or None.
10. Go to step 20.
Note: If an MSS-1 is in use, the E1/T1 option is displayed instead of E1/DS1.
Note: If a Sync-In/Out SFP is in use, the Sync Ports area is labeled Sync In/Out
SFPs. The Sync In Port appears as NOT USED. The SFP is displayed as Sync
In Port #5, #6, #7, #8, depending on where the SFP is placed; see Figure 186.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...