Configure radio parameters
864
WebEML User Manual
ix. Enter the MPT-HC/HQAM radio channel User Label, if applicable.
x. Click Apply.
41. Select an action.
a. To Provision the MPT ODU 1+1 FD spare radio channel, go to step 45.
b. To Provision the MPT ODU Manual Transmit Power Level (RTPC), go to
step 48.
c. To Provision the MPT ODU Automatic Transmit Power Control (ATPC), go
to step 53.
42. Provision the radio for Adaptive Modulation
Open the appropriate radio main view depending on your radio configuration
and select the Settings tab; see Figure 650.
Note: The Channel #1 Rx Freq (KHz) field displays the Rx RF Frequency and is the result
of the following calculation: RX Frequency = TX Frequency - Shifter Frequency
Note: In a Protected radio configuration, the Main and Protect radio channels use the same
CT screen. The parameters on the Spare (Channel #0) part of the screen are the same as
the Main (Channel #1) part of the screen. Channel #0 fields will be automatically populated
to match Channel #1.
Note: For MPT-HC-HQAM/XP-HQAM, the Reference Modulation should be set to a value
lower than or equal to 256 QAM.
In the ANSI market for MPT-HC-HQAM/XP-HQAM, the Reference Modulation should also
be equal to the Minimum modulation.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...