Administer L1/L2 radio and L2 Ethernet LAG
ports
312
WebEML User Manual
9. Verify L2 Radio LAG port provisioning.
To provision an L2 Ethernet LAG port
1. Using the craft terminal, verify all user Ethernet ports to be members of the L2
Ethernet LAG port are provisioned the same. Correct any user Ethernet
provisioning that does not correspond to the desired LAG performance
characteristics. Verify the following parameters:
− Advertised Capability (only Full Duplex supported)
− Auto Negotiation: Enable or Disabled (All either enabled or disabled)
− Synchronous Ethernet Operation Mode
2. Using the craft terminal, verify all user Ethernet ports, to be members of the LAG
port, are not associated with the following:
− Cross-Connection
− Port Segregation
− VLAN
3. If the Ethernet ports that will be members of the L2 Ethernet LAG port will be
used as TMN in-band interfaces, verify that the TMN in-band has been
configured and that the Ethernet ports that will be included in the LAG have been
selected. See Administer In-Band TMN VLAN port.
4. Create L2 Ethernet LAG port.
5. Add User Ethernet ports to L2 Ethernet LAG port.
6. Provision VLAN Configuration.
Note: For a detailed procedure to create L2 Ethernet LAG port, see To create an L1/L2
Radio or L2 Ethernet LAG port.
Note: For a detailed procedure to add Ethernet ports to a LAG port, see To add Ethernet or
radio ports to LAG port, step 1.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...