WebEML User Manual Administer L1/L2 radio and L2 Ethernet LAG
ports
311
2. Using the craft terminal, verify all radio ports, to be members of the L2 Radio
LAG port, are not associated with the following:
− Cross-Connection
− Port Segregation
− VLAN
− PPP RF enabled on the radio channel
− MPT-HL radio connected to a Core-E card
− MPT-HLC radio connected to a Core-E or P8ETH card
3. Create L2 Radio LAG port.
4. Add Radio ports to L2 Radio LAG port.
5. Provision PPP RF Configuration. The Remote IP Address field shows the IP
address of the remote connected NE.
6. From the LAG Information pane Hash drop-down menu, select hashing level:
(L2 or L3).
7. From the LAG Information pane, select Enabled check box (checked).
8. Click Apply.
Note: For a detailed procedure to create L2 Radio LAG port, see To create an L1/L2 Radio
or L2 Ethernet LAG port.
Note: For a detailed procedure to add radio ports to an L2 Radio LAG port, see To add
Ethernet or radio ports to LAG port.
Note: For a detailed procedure to provision PPP RF Configuration, see To administer PPP
RF configuration.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...