WebEML User Manual Configure radio parameters
787
59.3 Prerequisites
To provision a radio, the supporting radio port (card, or card plus port) must be
provisioned before beginning the procedures in this chapter.
59.4 Procedures
This section provides the following procedures:
• To open the Radio Main View
• To administer the MPT-HL transceiver
• To provision the MPT-HLC transceiver
• To administer the MPT-HLS transceiver
• To administer the MPT ODU
• To provision the radio for fixed modulation using data help
• To provision the radio for adaptive modulation using data help
• To administer the Tx Mute settings
• To administer the ACM Manual settings
• To remove XPIC
No Tx Radio Alarms alarm profile — Must be configured in the radio
panel (otherwise all the Tx Radio
alarms will be raised)
Tx Mute — Transmitter must be muted with
Tx Mute command
Space diversity combiner for
MPT-HLS
Should not be equipped on the
Tx side
Can be equipped only on the
receiver side
RF switch for MPT-HLS Should be mounted and
connected
Should be mounted and
connected
Table 6 Configurations in monodirectional links (Continued)
Parameter Tx only node Rx only node
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...