Configure radio parameters
848
WebEML User Manual
ii. Click Apply.
To administer the MPT ODU
1. Select an action.
a. To Provision the MPT ODU power scheme, go to step 2.
b. To Provision the MPT ODU co-channel XPIC configuration, go to step 7.
c. To Provision the MPT ODU 1+1 XPIC configuration, go to step 18.
d. To Provision the MPT ODU radio protection type, go to step 29.
e. To Provision the radio for fixed modulation, go to step 39.
f. To Provision the radio for Adaptive Modulation, go to step 42.
g. To Provision the MPT ODU 1+1 FD spare radio channel, go to step 45.
h. To Provision the MPT ODU Manual Transmit Power Level (RTPC), go to
step 48.
i. To Provision the spare MPT ODU RTPC, go to step 51.
j. To Provision the MPT ODU Automatic Transmit Power Control (ATPC), go
to step 53.
k. To Provision the spare MPT ODU ATPC, go to step 56.
l. To Provision the MPT ODU radio protection scheme, go to step 58.
m. To Provision the MPT ODU link identifier, go to step 66.
n. To Provision the MPT ODU Synchronization Status Messaging, go to
step 68.
o. To Provision the MPT ODU Point to Point Protocol settings, go to step 69.
p. To Provision the PKT throughput booster setting, go to step 70.
q. To Administer the MPT ODU Alarm Profile settings, go to step 71.
r. To Provision the MPT ODU radio channel encryption, go to step 72.
s. To Configure the Low Voltage Alarm for the MPT-HQAM, go to step 73.
2. Provision the MPT ODU power scheme
Provision MPT ODU power scheme
Note: MPT ODU power scheme provisioning applies to MPT ODUs enabled on the
MPTACC card, MSS-1 Core with PFoE support, EASv2 with PFoE support, or MSS-O with
PFoE support.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...