WebEML User Manual Administer L1/L2 radio and L2 Ethernet LAG
ports
309
2. Using the craft terminal, verify all radio ports, to be members of the L1 Radio
LAG port, are not associated with the following:
a. Cross-Connection
b. VLAN
c. Port Segregation
d. PPP RF enabled on the radio channel
e. Synchronization reference
f. SSM
g. Pkt throughput booster enabled (except MPT-HL on EASv2)
h. MPT-HL radio connected to a Core card
i. MPT-HLC radio connected to a Core or P8ETH card
3. Create L1 Radio LAG port.
4. Add Radio ports to L1 Radio LAG port.
5. Provision WTR parameter.
6. Provision PPP RF Configuration.The Remote IP Address field shows the IP
address of the remote connected NE.
Note: For a detailed procedure to create L1 Radio LAG port, see To create an L1/L2 Radio
or L2 Ethernet LAG port.
Note: For a detailed procedure to add radio ports to an L1 Radio LAG port, see To add
Ethernet or radio ports to LAG port.
Note: For a detailed procedure to provision WTR parameter, see To provision Wait-To-
Restore (WTR) value.
Release 7.0.0 3DB 19286 ACAA Issue 01
To Next Page
Loading...