www.ti.com
General-Purpose Input/Output (GPIO)
109
SPRUI07–March 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
System Control and Interrupts
Table 1-52. GPIO Port B MUX 1 (GPBMUX1) Register Field Descriptions (continued)
Bit Field Value Description
23:22 GPIO43 Configure this pin as:
00 GPIO 43 - general purpose I/O 43 (default)
01 Reserved
10 or
11
XA3 - External interface (XINTF) address line 3 (O)
21:20 GPIO42 Configure this pin as:
00 GPIO 42 - general purpose I/O 42 (default)
01 Reserved
10 or
11
XA2 - External interface (XINTF) address line 2 (O)
19:18 GPIO41 Configure this pin as:
00 GPIO 41 - general purpose I/O 41 (default)
01 Reserved
10 or
11
XA1 - External interface (XINTF) address line 1 (O)
17:16 GPIO40 Configure this pin as:
00 GPIO 40 - general purpose I/O 40 (default)
01 Reserved
10 or
11
XA0/XWE1 - External interface (XINTF) address line 1 or external interface write enable strobe 1
(O)
15:14 GPIO39 Configure this pin as:
00 GPIO 39 - general purpose I/O 39 (default)
01 Reserved
10 or
11
XA16 - External interface (XINTF) address line 16 (O)
13:12 GPIO38 Configure this pin as:
00 GPIO 38 - general purpose I/O 38 (default)
01 Reserved
10 or
11
XWE0 - External interface write enable strobe 0
11:10 GPIO37 Configure this pin as:
00 GPIO 37 - general purpose I/O 37 (default)
01 ECAP2 - Enhanced capture input/output 2 (I/O)
10 or
11
XZCS7 - External interface zone 7 chip select (O)
9:8 GPIO36 Configure this pin as:
00 GPIO 36 - general purpose I/O 36 (default)
01 SCIRXDA - SCI-A receive data (I)
10 or
11
XZCS0 - External interface zone 0 chip select (O)
7:6 GPIO35 Configure this pin as:
00 GPIO 35 - general purpose I/O 35 (default)
01 SCITXDA - SCI-A transmit data (O)
10 or
11
XR/W - Read Not Write Strobe. Normally held high. When low, XR/W indicates write cycle is active;
when high, XR/W indicates read cycle is active.
5:4 GPIO34 Configure this pin as:
00 GPIO 34 - general purpose I/O 34 (default)
01 ECAPI - Enhanced capture input/output 1 (I/O)
10 or
11
XREADY - External interface ready signal