Release : 1.1f 104 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
3.66 speed
This command sets the speed of the interface and the no form of the command sets the speed of
the interface to its default value.
speed { 10 | 100 | 1000 | 10000 | auto }
no speed
Syntax Description
10 - Port runs at 10Mbps
100 - Port runs at 100Mbps
1000 - Port runs at 1000Mbps
10000 - Port runs at 10000Mbps
Auto - Port automatically detects the speed it must run on based on the peer switch.
Mode
Interface Configuration Mode
Defaults
auto
Example
SMIS(config-if)# speed 100
The Gigabit Ethernet port speed can be configured to 10, 100, or 1000 Mbps.
If the speed is set to auto, the switch negotiates with the device at the other end of the link for the
speed setting and then forces the speed setting to the negotiated value.
This parameter cannot be set if the port is automatically negotiating the link parameters with its
peer. In that case, use the command "no-negotiation" to be able to set speed of the link and
indicate whether it is full or half duplex.
Related Commands
negotiation - Enables auto-negotiation on the interface
duplex - Configures the duplex operation
To Next Page
Loading...
