Supermicro SSE-G48-TG4 - Ip Pim Hello-Holdtime

Release : 1.1f 552 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
22.18 ip pim hello-holdtime
This command sets the holdtime for the hello message for that interface. The no form of the
command sets the default holdtime (105) for the hello message for that interface.
ip pim hello-holdtime <holdtime(1-65535)>
no ip pim hello-holdtime
Mode
Interface Configuration Mode
Defaults
105
Example
iss (config-if)# ip pim hello-holdtime 180
Holdtime is the amount of time a receiver must keep the neighbor reachable, in seconds.
Related Commands
show ip pim neighbor – Displays the routers PIM neighbors information
show ip pim interface – Displays the routers PIM interfaces