Release : 1.1f 928 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
33.14 redirect udp
This command specifies the UDP packets to be redirected based on the associated parameters.
redirect <interface-type> <interface-id> udp { any | host <src-ip-
address> | <src-ip-address> <src-mask>} [{gt <port-number (0-65535)> |
lt <port-number (1-65535)> | eq <port-number (0-65535)> | range <port-
number (0-65535)> <port-number (0-65535)>}] { any | host <dest-ip-
address> | <dest-ip-address> <dest-mask> } [{ gt <port-number (0-
65535)> | lt <port-number (1-65535)> | eq <port-number (0-65535)> |
range <port-number (0-65535)> <port-number (0-65535)>}] [{tos{max-
reliability|max-throughput|min-delay|normal|<tos-value(0-7)>} | dscp
<value (0-63)>}] [ priority <(1-255)>]
Syntax Description
interface-type – may be any of the following:
gigabitethernet – gi
extreme-ethernet – ex
qx-ethernet – qx
interface-id - is in slot/port format for all physical interfaces
udp - User Datagram Protocol
any| host <src-ip-address>| <src-ip-address> <src-mask> - Source IP address
can be 'any' or the word 'host' and the dotted decimal address or number of the network or the
host that the packet is from and the network mask to use with the source address
port-number - Port Number. The input for the source and the destination port-number is
prefixed with one of the following operators.
eq=equal
lt=less than
gt=greater than
range=a range of ports; two different port numbers must be specified
any|host <dest-ip-address> |<dest-ip-address> <dest-mask> - Destination IP
address can be 'any' or the word 'host' and the dotted decimal address or number of the network
or the host that the packet is destined for and the network mask to use with the destination
address
tos - Type of service. Can be max-reliability, max throughput, min-delay, normal or a range of
values from 0 to 7, Differentiated Services Code Point (DSCP) values to match against incoming
packets.
To Next Page
Loading...
