Release : 1.1f 885 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
31.49 show ipv6 ospf areas
This command displays the Area Table.
show ipv6 ospf areas
Mode
User/Privileged EXEC Mode
Example
SMIS# show ipv6 ospf areas
OSPFv3 AREA CONFIGURATION INFORMATION
AreaId: 0.0.0.0 Area Type: NORMAL AREA
Spf Calculation: 3 (times) Area Bdr Rtr Count: 1
As Bdr Rtr Count: 0 Area Summary: Send Summary
AreaId: 0.0.0.1 Area Type: NSS AREA
Spf Calculation: 0 (times) Area Bdr Rtr Count: 1
As Bdr Rtr Count: 0 Area Summary: Send Summary
Stub Metric: 0x1 Stub Metric Type: 1
Translator Role: Candidate Translator State: Disabled
Nssa Stability Interval: 40
Related Commands
area - stub/nssa – Defines an area as a stub area or an NSSA (Not So Stubby Area)
area - stability-interval – Configures the stability interval (in seconds) for the NSSA
area - translation-role – Configures the translation role for NSSA
no area – Deletes an area
To Next Page
Loading...
