Release : 1.1f 216 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
9.20 spanning-tree pathcost dynamic
This command enables dynamic pathcost calculation and the no form of the command disables
dynamic pathcost calculation.
spanning-tree pathcost dynamic
no spanning-tree pathcost dynamic
Mode
Global Configuration Mode
Defaults
Disabled
Example
SMIS(config)# spanning-tree pathcost dynamic
On execution of this command, the pathcost of all the ports will be calculated dynamically based
on the speed of the interface.
If the cost has already been configured for a cist or an rstp interface, then this
command has no effect on those interfaces.
If the cost has been configured previously for an mst instance on a particular
interface, then this command has no effect on that instance in the specified
interface. Whereas the pathcost of all the other instances on the same interface will
be calculated dynamically.
Related Commands
spanning-tree pathcost method – Sets the method to calculate the port path cost
spanning-tree compatibility– Sets the compatibility version for the spanning tree
protocol
spanning-tree - Properties of an interface – Sets the spanning tree properties of
an interface
spanning-tree mst- Properties of an interface for MSTP – Sets the spanning
tree properties of an interface for MSTP
To Next Page
Loading...
