Release : 1.1f 693 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
26.41 show ip ospf info
This command displays general information about the OSPF routing process.
show ip ospf info
Mode
Privileged EXEC Mode
Example
SMIS# show ip ospf info
OSPF Router ID 10.0.0.1
Supports only single TOS(TOS0) route
ABR Type supported is Standard ABR
Number of Areas in this router is 1
Area is 33.0.0.12
Number of interfaces in this area is 2
SPF algorithm executed 3 times
Related Commands
area - Stability interval – Configures the Stability interval for NSSA
area - virtual-link – Defines an OSPF virtual link and its related parameters
ip ospf authentication-key – Specifies a password to be used by neighboring routers
that are using the OSPF simple password authentication
debug ip ospf – Sets the OSPF debug level
To Next Page
Loading...
