Supermicro SSE-G48-TG4 - Ipv6 Pim Hello-Holdtime

Release : 1.1f 588 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
23.16 ipv6 pim hello-holdtime
This command sets the holdtime for the hello message for the PIMv6 interface. The no form of
the command sets the default holdtime for the hello message for the interface.
ipv6 pim hello-holdtime <holdtime(1-65535)>
no ipv6 pim hello-holdtime
Mode
Interface Configuration Mode
Defaults
105
Example
iss (config-if)# ipv6 pim hello-holdtime 180
Holdtime is the amount of time a receiver must keep the neighbor reachable, in seconds.
Related Commands
show ipv6 pim neighbor – Displays the PIMv6 neighbor(s) information of the router