Release : 1.1f 114 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
3.76 show ip interface
This command displays the IP interface configuration.
show ip interface [Vlan <vlan-id(1-4069)>] [<interface-type>
<interface-id>] [loopback <loopback-id(1-100)>]
Syntax Description
Vlan - VLAN Identifier any nymber between 1 to 4069
interface-type - Interface type, can either be a gigabit Ethernet or extreme Ethernet (10Gig)
or qx Ethernet (40Gig) interface.
interface-id - Physical interface ID including slot and port number.
loopback - Loopback interface ID any nymber between 1 to 100
Mode
Privileged EXEC Mode
Example
SMIS# show ip interface
vlan1 is up, line protocol is up
Internet Address is 12.0.0.2/8
Broadcast Address 12.255.255.255
Secondary Address 12.0.0.10/8
Secondary Address 13.0.0.10/
If executed without the optional parameters this command displays the IP interface
statistics and configuration for all the available interfaces.
Related Commands
interface - Configures an interface, which can be a physical interface or a port-channel
interface or a VLAN interface
show interfaces - Displays the interface status and configuration
To Next Page
Loading...
