Release : 1.1f 130 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
3.90 set boot-up
This command configures the next bootup firmware image selection. The default bootup image
selection is normal image. User can use this command to boot the switch from fallback image on
next reboot.
set boot-up {normal | fallback}
Syntax Description
normal - Switch boots using normal firmware image on next reboot
fallback - Switch boots using fallback firmware image on next reboot
Mode
Global Configuration Mode
Default
normal
Example
SMIS(config)# set boot-up fallback
Related commands
show system information – Displays the next boot image selection
information along with other system parameters.
To Next Page
Loading...
