Release : 1.1f 831 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
31.4 area - stability-interval
This command configures the stability interval (in seconds) for the NSSA. The no form of the
command sets the default value of the stability interval for the NSSA.
area <area-id> stability-interval <1-65535>
no area <area-id> stability-interval
Syntax Description
area-id - A 32 bit integer
stabilityinterval - The number of seconds after which an elected translator determines
that its services are no longer required, and that it must continue to perform its translation duties.
Mode
Router Configuration Mode
Defaults
interval-value - 40
Example
SMIS(config-router)# area 0.0.0.1 stability-interval 50
Related Command
show ipv6 ospf areas – Displays the Area Table
To Next Page
Loading...
