Release : 1.1f 895 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
32.6 set cos
This command defines the in-profile action by setting a class of service (CoS), Differentiated
Services Code Point (DSCP), or IP-precedence value in the packet.
The no form of the command deletes the configured values.
set {cos <new-cos(0-7)> | ip dscp <new-dscp(0-63)> | ip precedence
<newprecedence( 0-7)>}
no set {cos <new-cos(0-7)> | ip { dscp <new-dscp(0-63)> | precedence
<newprecedence( 0-7)>}}
Syntax Description
cos - New COS value assigned to the classified traffic
ip dscp - New DSCP value assigned to the classified traffic
ip precedence - New IP-precedence value assigned to the classified traffic
Mode
Policy-Map Class Configuration Mode
Example
iss (config-pmap-c)# set cos 5
To attach policy maps that contain the following elements to an ingress interface
- set policy-map class configuration commands must be used. Moreover, the police
policy-map class configuration command can be used to mark down (reduce) the DSCP
value at the ingress interface.
- Access control list (ACL) classification.
- Per-port per-VLAN classification.
Related Commands
class- Defines a traffic classification for the policy set
policy-map - Used to enter the policy map configuration mode
class-map - Creates a class map
show policy-map - Displays the QoS policy map configuration
To Next Page
Loading...
