Release : 1.1f 656 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
26.9 area- nssa
This command configures an area as a NSSA and other parameters related to that area.
area <area-id> nssa [{ no-summary | default-information-originate
[metric <value>] [metric-type <Type(1-3)>] [tos <tos value (0-30)>] }]
Syntax Description
area-id - Area associated with the OSPF address range. It is specified as an IP address
nssa - Configures an area as a not-so-stubby area (NSSA)
no-summary - Allows an area to be a not-so-stubby area but not have summary routes injected
into it
defaultinformationoriginate - Default route into OSPF
metric - The Metric value applied to the route before it is advertised. into the OSPF Domain
metric-type - The Metric Type applied to the route before it is advertised. into the OSPF
Domain
tos - Type of Service of the route being configured
Mode
Router Configuration Mode
Defaults
metric - 10
metric-type - 1
tos - 0
Example
SMIS(config-router)# area 10.0.0.1 nssa
The no area <area-id> [{ stub | nssa }] command removes an area or
converts stub/nssa to normal area.
tos can be configured only if the code is compiled with TOS Support
Related Commands
area - range – Consolidates and summarizes routes at an area boundary
area - translation-role– Configures the translation role for the NSSA
To Next Page
Loading...
