Release : 1.1f 427 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
16.3.7 network
This command sets the network IP address and mask in DHCP server configuration parameters.
The no form of the command deletes the network IP address and mask from DHCP server
configuration.
network <network- IP> [ { <mask> | / <prefix-length (1-31)> } ] [end
ip]
no network
Syntax Description
network-IP - Network IP address of the DHCP pool
mask - Subnet mask of the DHCP pool
prefix-length - The number of bits that comprise the address prefix. Prefix is an alternative
way of specifying the network mask of the client. The prefix length must be preceded
by a forward slash (/).
end ip - End IP address of the pool
Mode
DHCP Pool Configuration Mode
Example
SMIS(dhcp-config)# network 20.0.0.0 255.0.0.0 20.0.0.10
This command is valid for DHCP sub network address pools only.
Related Commands
service dhcp-server - Enables the DHCP server
show ip dhcp server information - Displays the server information
show ip dhcp server pools - Displays the DHCP server pools
show ip dhcp server binding - Displays the DHCP server binding information
show ip dhcp server statistics - Displays the DHCP server statistics
To Next Page
Loading...
