Release : 1.1f 585 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
23.13 ipv6 pim message-interval
This command sets the frequency at which the PIMv6 Join/Prune messages are transmitted on
the PIMv6 interface. The no form of the command sets the default value for the PIMv6 Join/Prune
messages.
ipv6 pim message-interval <Interval(0-65535)>
no ipv6 pim message-interval
Mode
Interface Configuration Mode
Defaults
60
Example
iss (config-if)# ipv6 pim message-interval 120
The Join/Prune message interval used on all the PIMv6 routers in the PIMv6 domain
must be the same. If all the routers do not use the same timer interval, the performance
of PIMv6 Sparse can be adversely affected.
Related Command
show ipv6 pim interface – Displays the PIMv6 interfaces of the router
To Next Page
Loading...
