Supermicro SSE-G48-TG4 - Set Nssa Asbr-Default-Route Translator

Release : 1.1f 670 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
26.19 set nssa asbr-default-route translator
This command enables/disables setting of P bit in the default Type-7 LSA generated by NSSA
internal ASBR.
set nssa asbr-default-route translator { enable | disable }
Syntax Description
enable - When set to enabled, P-Bit is set in the generated Type-7 default LSA
disable - When set disabled, P-Bit is clear in the generated default LSA
Mode
Router Configuration Mode
Defaults
disable
Example
SMIS(config-router)# set nssa asbr-default-route translator enable
Specifies the P-Bit setting for the default Type-7 LSA generated by ASBR(which is not ABR).
Related Command
ASBR Router – Specifies this router as ASBR