Release : 1.1f 682 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
26.31 ip ospf authentication
This command specifies the authentication type for an interface and the no form of the command
removes the authentication type for an interface and set it to NULL authentication.
ip ospf authentication [{message-digest | null}]
no ip ospf authentication
Syntax Description
message-digest - Message Digest authentication
null - NULL authentication
Mode
Interface Configuration Mode
Defaults
null
Example
SMIS(config-if)# ip ospf authentication
Before using the ip ospf authentication command, a password for the interface must be
configured using the ip ospf authentication-key command.
If the authentication type is ‘message digest’ then key will be selected from the md-
5 table.
Related Commands
area-stub – Specifies an area as a stub area and other parameters related to that area
area-default cost – Specifies a cost for the default summary route sent into a stub or
NSSA
area - virtual-link – Defines an OSPF virtual link and its related parameters
area - range – Consolidates and summarizes routes at an area boundary
ip ospf authentication-key – Specifies a password to be used by neighboring routers
that are using the OSPF simple password authentication
ip ospf message-digest-key – Enables OSPF MD5 authentication
To Next Page
Loading...
